![]() This is called a trickle charging mechanism. Once the power has turned on, the battery will begin to charge by itself for future usage. The battery is used to prevent the alarm system goes off when there is a power outage. It is best practice to test your alarm system while it is still in test mode.īecause most of the security alarm uses a power supply to get the electricity, the alarm battery recharge by itself.Charge your empty battery for 24 hours.Just the reverse of what we did before and you are good to go. Once everything is indicated that it is on, close the cover and put back the screws or simply lock if you are using a key.The next thing to do will get to go to the alarm panel and turn the alarm on and then off again to clear the fault that would have been displayed indicating the battery was low. Well, now you have a fresh battery in there.Because you don’t want that there’s a problem like no sirens, nothing like that. Of course, it is very important that Red goes to Red and Black goes to Black.Place the new or your backup battery on the panel box and attach the leads to the new battery.Then take out the battery from the panel box.Remove the red and black battery leads that are attached to the battery.You will see there is a red and a black wire on the battery.Now you will see there are lots of wires and scary-looking bits, but it’s all very straightforward the big black thing at the bottom of the alarm panel box is the battery.Once you have removed the screws, carefully open the cover towards you.If there is no key, you will need to remove the screws on whichever side of your panel box. Using your panel box key, open the front cover of the alarm panel.Make sure you are facing and ready to open up the complete kit of the Bosch alarm system.Just so you know, in this article we are using Bosch Solution 3000 Kit and Aus Cell 12V7Ah Alarm Battery. It is very easy and we will cover a step-by-step on how you can replace the alarm battery in a very complete step. How cool is it?Īpparently, it is not that complicated as you ever think. At the end of this blog, you will also know how to charge your empty battery. Therefore, in this blog, we will tell you how to remove the battery and replace it with your 12V 7Ah rechargeable alarm backup battery. You might already know that maybe every 2, 3, 4, or 5 years, your alarm panel will tell you when the battery is low, has trouble, and need to be replaced with the alarm backup battery. ![]() How to Change and Charge a Backup Battery in Alarm System
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |